• car parks
• parking lots
• drives, paths
• fire access roads
• securing gradients
• light aircraft landing sites
• root protection
• grassed rails
• bank protection

• occasionally used parking lots
• parking lots with less trafficking
• golf paths
• pedestrian access
• venue areas
• grassed areas with less trafficking
• securing gravel grassed areas
• protecting grassed areas in public
• camping sites

• protects grassed areas from loads
• rapid surface drainage
• no sewage fees
• fast installation
• excellent design

• is placed onto a gravel sub-base
• an additional grading layer is not required
• the pavers are filled with fine soil or gravel

• is placed without a sub-base
• is placed onto gravel grassed areas or existing lawn areas
• pavers must not be filled

• paver unit size: 50x50x5cm, wall thickness 4mm, treading layer 10mm, ready to lay n 1 m2, weight 9kg/m2
• integrated circular joints for balancing tensions and strains each 50cm in longitudinal and traverse direction
• the surface is non-slipping  
• all grid-chambers are open towards the bottom for an optimum water drainage; thus root growth is ideal
• material: pure recycled polyethylene, absolutely environment-friendly, suitable for water conservation areas

• paver unit size: 50x50x2.5cm, wall thickness 5mm, treading layer 16mm, ready to lay on 1m2, weight 4.5kg/m2
• integrated circular joints for balancing tensions and strains each 50cm in longitudinal and traverse direction
• the surface in non-slipping
• all grid-chambers are open towards the bottom for an optimum water drainage; thus root growth is ideal
• material: pure recycled polyethylene, absolutely environment-friendly, suitable for water conservation areas

• Level ground with a gradient of 1 to 2 %.
• Place a 20 to 40 cm thick layer of gravel or crushed aggregate over the ground according to your requirements and to the load that is to be absorbed. Use a material permeable to water for areas without a grassed finish. Use unwashed gravel or mineralized concrete for better root growth for grassed areas.
• Install and compress the sub-base.
• Place G-PRO pavers onto the gravel layer. Pavers can be cut to fit around obstructions and contours. Fill GS-PRO pavers with specifies sand and substrate. Finished levels should be 1 cm below the top of the cells after settlement. Apply the selected seed mix for GS-PRO pavers.

New Grass:

• Place GS-ONTOP onto the top of grass surfaces or gravel grassed areas. It can be applied onto leveled new grass or turf roll.
• Apply an appropriate fertilizer.

Existing Grassed Areas/Gravel Grassed Areas:

• Cut the existing grass as short as possible.
• Ensure that the surface is reasonably leveled
• Place GS-ONTOP onto the grass. It can be cut with suitable shears to work round trees, edges and other obstacles. Level the surface once more, if required.
• Apply an appropriate fertilizer.

• We offer appropriate white marker caps in order to mark parking areas as required